51單片機串口檢測程序

＃i nclude reg51_STC.H
#define uchar unsigned char
#define uint unsigned int

//--------------------------------------------------------------------------
//函數名稱: UART_Init()
//函數功能: 串口初始化函數,在系統時鐘為11.059MHZ時，設定串口波特率為9600bit/s
//其他說明: 串口接收中斷允許，發送中斷禁止
//--------------------------------------------------------------------------

void UART_Init(void)
{
SCON = 0x50 ; //SCON: serail mode 1, 8-bit UART, enable ucvr
TMOD |= 0x20 ; //TMOD: timer 1, mode 2, 8-bit reload
PCON |= 0x80 ; //SMOD=1;
TH1 = 0xFA ; //Baud:9600 fosc=11.0592MHz
ES=1;
TR1 = 1 ; // timer 1 run
EA=1;
}


//--------------------------------------------------------------------------
//函數名稱: main(void)
//函數功能: 主函數
//其他說明: 無
//--------------------------------------------------------------------------

void main(void)
{
UART_Init();
while(1);
}


//--------------------------------------------------------------------------
//函數名稱: Uart_SendData()
//函數功能: 串口發送一個字節的數據
//其他說明: 此程序供中斷調用
//--------------------------------------------------------------------------

void Uart_SendData(uchar dat)
{
SBUF=dat; //寫SBUF，開始發送
while(TI==0); //等待發送
TI=0; //清發送標志位
}


//--------------------------------------------------------------------------
//函數名稱: INT_UartRcv()
//函數功能: 串口接收中斷函數
//其他說明: 無
//--------------------------------------------------------------------------

void INT_UartRcv(void) interrupt 4
{
uchar Rcv;
if(RI)
{
RI=0; //
Rcv=SBUF;
Uart_SendData(Rcv); //返回接收數據,可以改為其他函數
}
}

NO。2

＃i ncludereg52.h>
＃i nclude string.h>
#define INBUF_LEN 4 //數據長度
unsigned char inbuf1[INBUF_LEN];
unsigned char checksum,count3;
bit read_flag= 0 ;
void init_serialcomm( void )
{
SCON = 0x50 ; //SCON: serail mode 1, 8-bit UART, enable ucvr
TMOD |= 0x20 ; //TMOD: timer 1, mode 2, 8-bit reload
PCON |= 0x80 ; //SMOD=1;
TH1 = 0xF4 ; //Baud:4800 fosc=11.0592MHz
IE |= 0x90 ; //Enable Serial Interrupt
TR1 = 1 ; // timer 1 run
EA=1;
}

//向串口發送一個字符