<meter id="pryje"><nav id="pryje"><delect id="pryje"></delect></nav></meter>
          <label id="pryje"></label>

          新聞中心

          EEPW首頁 > 模擬技術 > 設計應用 > 基于LMP8358的高精度可編增益儀表放大器設計方案

          基于LMP8358的高精度可編增益儀表放大器設計方案

          作者: 時間:2010-04-12 來源:網絡 收藏
          可編儀表放大器,通過SPI兼容的串口或并口可把編程為0,20,50,100,200,500,或1000,也可用兩個外設電阻設定為任意值.單電源2.7V 到5.5V工作,電流為1.8 mA,最大誤差為0.15%,增益漂移為16 ppm/℃,CMRR大于110 dB,失調電壓小于10 μV,失調電壓漂移小于50 nV/℃,增益帶寬GBW(增益=10)8MHz,非線性小于100 ppm,主要用在橋接傳感器放大,熱堆放大,手提儀表,醫療設備.本文主要介紹主要特性,功能方框圖,典型應用方框圖,菊花和星形鏈接配置圖以及差分橋接傳感器應用電路圖.

          The is a precision programmable-gain instrumentation amplifier in National’s LMP precision amplifier family. Its gain can be programmed to 10, 20, 50, 100, 200, 500, or 1000 through an SPI-compatible serial interface or through a parallel interface. Alternatively, its gain can be set to an arbitrary value using two external resistors. The LMP8358 uses patented techniques to measure and continuously correct its input offset voltage, eliminating offset drift over time and temperature and the effect of 1/f noise. Its ground-sensing CMOS input features a high CMRR and low input bias currents. It is capable of sensing differential input voltages in a commonmode range that extends from 100mV below the negative supply to 1.4V below the positive supply, making it an ideal solution for interfacing with ground-referenced sensors, supply- referenced sensor bridges, and any other application requiring precision and long-term stability. Additionally, the LMP8358 includes fault detection circuitry to detect open and shorted inputs and deteriorating connections to the signal source. Other features that make the LMP8358 a versatile solution for many applications are its rail-to-rail output, low input voltage noise and high gain-bandwidth product.

          LMP8358主要特性:

          Typical Values unless otherwise noted, TA = 25℃

          ■ Supply voltage 2.7V to 5.5V

          ■ Supply current 1.8 mA

          ■ Max gain error 0.15%

          ■ Max gain drift 16 ppm/℃

          ■ Min CMRR 110 dB

          ■ Max offset voltage 10 μV

          ■ Max offset voltage drift 50 nV/℃

          ■ GBW (gain = 10) 8 MHz

          ■ Max non-linearity 100 ppm

          ■ Operating temperature range 40℃ to 125℃

          ■ Input fault detection

          ■ SPI or pin configurable modes

          ■ EMIRR at 1.8GHz 92 dB

          ■ 14-Pin SOIC and 14-Pin TSSOP Package

          LMP8358應用:

          ■ Bridge sensor amplifier

          ■ Thermopile amplifier

          ■ Portable instrumentation

          ■ Medical instrumentation

          ■ Precision low-side current sensing

          圖1.LMP8358方框圖

          上一頁 1 2 下一頁

          關鍵詞: 8358 LMP 高精度 增益

          評論


          相關推薦

          技術專區

          關閉
          看屁屁www成人影院,亚洲人妻成人图片,亚洲精品成人午夜在线,日韩在线 欧美成人 (function(){ var bp = document.createElement('script'); var curProtocol = window.location.protocol.split(':')[0]; if (curProtocol === 'https') { bp.src = 'https://zz.bdstatic.com/linksubmit/push.js'; } else { bp.src = 'http://push.zhanzhang.baidu.com/push.js'; } var s = document.getElementsByTagName("script")[0]; s.parentNode.insertBefore(bp, s); })();