STM32F107VCT6的RCC配置

void RCC_Configuration(void)
{
ErrorStatus HSEStartUpStatus;

/* RCC system reset(for debug purpose) */
RCC_DeInit();

/* Enable HSE */
RCC_HSEConfig(RCC_HSE_ON);

/* Wait till HSE is ready */
HSEStartUpStatus = RCC_WaitForHSEStartUp();

if (HSEStartUpStatus != ERROR)
{
/* Enable Prefetch Buffer */
FLASH_PrefetchBufferCmd(FLASH_PrefetchBuffer_Enable);

/****************************************************************/
/* HSE=25MHz, HCLK=72MHz, PCLK2=72MHz, PCLK1=36MHz */
/****************************************************************/
/* Flash 2 wait state */
FLASH_SetLatency(FLASH_Latency_2);
/* HCLK = SYSCLK */
RCC_HCLKConfig(RCC_SYSCLK_Div1);
/* PCLK2 = HCLK */
RCC_PCLK2Config(RCC_HCLK_Div1);
/* PCLK1 = HCLK/2 */
RCC_PCLK1Config(RCC_HCLK_Div2);
/* ADCCLK = PCLK2/4 */
RCC_ADCCLKConfig(RCC_PCLK2_Div6);

/* Configure PLLs *********************************************************/
/* PPL2 configuration: PLL2CLK = (HSE / 5) * 8 = 40 MHz */
RCC_PREDIV2Config(RCC_PREDIV2_Div5);
RCC_PLL2Config(RCC_PLL2Mul_8);

/* Enable PLL2 */
RCC_PLL2Cmd(ENABLE);

/* Wait till PLL2 is ready */
while (RCC_GetFlagStatus(RCC_FLAG_PLL2RDY) == RESET)
{}

/* PPL1 configuration: PLLCLK = (PLL2 / 5) * 9 = 72 MHz */
RCC_PREDIV1Config(RCC_PREDIV1_Source_PLL2, RCC_PREDIV1_Div5);
RCC_PLLConfig(RCC_PLLSource_PREDIV1, RCC_PLLMul_9);

/* Enable PLL */
RCC_PLLCmd(ENABLE);

/* Wait till PLL is ready */
while (RCC_GetFlagStatus(RCC_FLAG_PLLRDY) == RESET)
{}

/* Select PLL as system clock source */
RCC_SYSCLKConfig(RCC_SYSCLKSource_PLLCLK);

/* Wait till PLL is used as system clock source */
while (RCC_GetSYSCLKSource() != 0x08)
{}
}
}