NXP PIP8000FHN數字電源監視方案
英飛凌汽車電子生態圈
NXP公司的PIP8000FHN是兼容電源管理總線(PMbus)協議的數字電源監視IC，通過主系統進行配置，以滿足多模式電源的動態轉換器的性能。PIP8000FHN的工作電壓為2.4 V 到3.6 V，I/O引腳5V容差。I2C總線的頻率高達400kHz。PIP8000FHN可用在DC分布電源系統，網絡應用，服務器及其附件，通信設備，工業/ATE電源，存儲系統以及AC/DC與DC/DC轉換器。本文介紹了PIP8000FHN 主要特性，方框圖以及典型應用框圖。
本文引用地址：http://www.ex-cimer.com/article/178110.htmThe PIP8000FHN is a Power Management Bus (PMBus) protocol compliant, digital power supervisor IC, configurable through a host system to meet dynamic converter performance for a multitude of power supply applications. The PIP8000FHN is able to manage power supply operating conditions as well as to monitor and report the status back to a host system using the PMBus protocol.
The PMBus standard uses the widely accepted Inter-Integrated Circuit (I2C) communication protocol for the hardware interface. A number of additional features are added to enhance the basic I2C communication protocol. These are described in the System Management Bus (SMBus) protocol and include SMAlert.
PIP8000FHN 主要特性：
PMBus serial interface:
Query I/O voltage, I/O current, warnings, faults
Query temperature for up to two temperature sensors
Configure and measure RPM for up to two fans
Sequence start-up and turn-off
Configurable 7-channel A/D with calibration factors
I2C device-address pin stripping
Compatible with most analog controllers
Power-on reset
I2C-bus up to 400 kHz
2.4 V to 3.6 V VDD operating range
5 V tolerant I/O pins
Thermal sense capabilities
28 pin HVQFN package, 6 mm x 6 mm
PIP8000FHN 應用：
PMBus compliant low voltage, high current density applications
DC power distributed systems
Networking applications
Servers and server accessories
Telecommunication systems
Industrial / ATE power applications
Storage systems
AC/DC and DC-to-DC applications
圖1。PIP8000FHN方框圖
圖2。PIP8000FHN應用框圖
評論